Sd Card / Usb Port - FUTABA T18MZ FASSTest-2.4GHz Instruction Manual

SD Card (sold separately)
The SD card can store various files, such as
model data, music, sound files and pictures. Any
SD card on the market can be used with the
T18MZ. The card is locked when it is pushed in all
the way in. To remove the card, push in on the card
again, it will pop up allowing you to remove it.
Warning
Be sure to turn off the power to the transmitter
before inserting or removing the SD card.
As the SD card is a precision device, do not use
excessive force when inserting.
If model data generated by a new software
version transmitter is copied to an old software
version transmitter, the transmitter may
operate erroneously. Copy the model data after
updating the copy destination transmitter to the
new software version.
Read data from a PC
Saving music and image files edited by a PC
into the SD card, you can use those files on your
T18MZ transmitter. Equipment for reading and
writing SD cards are available at most electronics
stores.
Stored data
The life of the SD card is limited due to the use
of Flash memory. If you have a problem saving or
reading data such as picture data after a long period
of use you may need to purchase a new SD card.
*We are not responsible for, and cannot compensate for any
failure to the data stored in the memory card for any reason.
Be sure to keep a backup of your models and data in your
SD card.
*No necessity for backup; T18MZ transmitters and SD
cards are using nonvolatile memory devices so that the data
stored in those will not be destroyed even without a backup
battery. The clock for the transmitter depends on the Lithium
battery.
Update Switch
When using an SD card to update the T18MZ
software, set this switch to the up position. Then
input the software to be updated to the SD card
from the Futaba importers homepage and update
the software in accordance with the updating
procedure.
USB port
The following functions can be used with USB
connector.
• USB Mouse
When a mouse is connected, a cursor will
appear on the screen and the mouse can
be used instead of the touch panel.
• USB Keybord
When a keyboard is connected, the model
name and other data can be input by
keyboard.
• USB Memory
All model data, etc. can be saved to an
optional USB Memory stick.
Connector for trainer function (TRAINER)
When you use trainer function, connect the
optional trainer cable between the transmitters for
teacher and student.
*You can set the trainer function on the Trainer Function
screen in the system menu
Connector for DSC function (DSC)
You can operate the transmitter without
transmitting radio waves by connecting the
transmitter and the receiver to the DSC cable.
*Please refer to the section "Connection between Receiver/
Servo"
S.BUS connector (S.I/F)
When setting an S.BUS servo and telemetry
sensor, connect them both here.
(Supply power by 3-way hub or 2-way cord.)
Audio plug (PHONE)
Connecting a stereo headphone to this plug, you
can enjoy music files stored in the SD card.
Connector for battery charger (CHG)
You cannot use the charger that was included
with the transmitter, without using the AC adapter
that comes with this.
Danger
Do not connect any other chargers. The charger
for the receiver battery cannot be used for the
transmitter.
USB port (mini-B)
*This is for factory use only.
<Before Use> 23