FUTABA T18MZ FASSTest-2.4GHz Instruction Manual page 111

●Camber Mix
This mixing adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
●ELE to Camber
This mixing is used when you want to the mix
camber flaps with elevator operation. Lift can be
increased with raised elevators. [Airplane/glider,
2 ailerons or more]
●Camber FLP to ELE
This mixing is used to correct for attitude changes
when the camber flaps are being used. [Airplane/
glider, 2 ailerons + 1 flap or more]
●Butterfly (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
●Trim Mix 1/2
The ailerons, elevators, and flaps trim offset rate can
be utilized by a switch or condition selection. [Glider,
2 ailerons or more]
●Airbrake
This function is used when airbrakes are necessary
when landing or when diving during flight.
(Airplane, general)
●Gyro
This is dedicated mixing when a gyro is used.
[Airplane/glider, general]
FLP 1
(Camber Flap)
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
ELEVATOR
(AILERON 5)
ELEVATOR
(RUDDER 2)
●V-tail
This function adjusts the elevators and rudder of
V-tail models. [Airplane/glider, V-tail specifications]
●Ailevator
This function adjusts the elevators and ailerons of
models with elevator specifications. [Airplane/
glider, elevator specifications]
●Winglet
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
specifications]
●Motor
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
●RUD to ELE
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
●Snap roll
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can
also be adjusted. [Airplane general]
●Multi Engine
This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines) [Airplane, general]
AIR BRAKE
FLP 4
FLP 3
(Brake Flap)
(Brake Flap)
RUDDER
ELEVATOR 2
(AILERON 6)
at AILEVATOR
V-TAIL
RUDDER
RUDDER 1
(ELEVATOR 2)
Winglet
(
at Flying wing
<Model Menu (Airplane/Glider Functions)>
FLP 2
(Camber Flap)
AIL 2
(Main Aileron)
AIL 4
(Chip Aileron)
at Flying wing
RUDDER 2
Winglet
(
at Flying wing
)
)
111