Service Jigs List - Sony DSR-20MD Service Manual

2-5. SERVICE JIGS LIST

Ref. No.
J-1 Cleaning fluid
J-2 Wiping cloth
Super fine applicator
J-3
(Made by NIPPON APPLICATOR (P752D))
J-4 Mirror (Small oval type)
Tracking tape (XH2-1AST) Standard cassette
J-5 Tracking tape (XH2-1ASE) Standard cassette
Tracking tape (XH2-1A1) Mini cassette
J-6 Mini DV torque cassette
J-7 Cassette standard plate (D/E mechanism)
J-8 Reel standard plate (D/E mechanism)
J-9 TG2/7 preset plate
J-10 Screwdriver for tape path
Adjusting remote commander
J-11
(RM-95 remodeled partly) Note l
J-12 Torque driver
J-13 Tension regulator adjustment board
J-14 CPC 8-jig
Other equipment used
• Oscilloscope
• DC power supply
• Digital voltage meter
Note 1: If the micro processor IC in the adjusting remote commander is not the new micro processor (UPD7503G-C56-12), the pages
cannot be switched.
In this case, replace with the new micro processor (8-759-148-35).
Tape path:
1. Make a checking and adjustment at the tape top using the XH1-1AST tape.
2. Then, make a checking with the XH2-1ASE (for tape end) and XH2-1A1 (Mini cassette for tape top and end).
3. Again make a checking with the XH2-1AST.
Name
Y-2031-001-0
7-741-900-53
J-6080-840-A
8-967-999-01
8-967-999-06
8-967-999-03
J-6082-360-A
J-6082-330-A
J-6082-331-A
J-6082-358-A
J-6082-026-A
J-6082-053-B
J-9049-330-A
J-6082-359-A
J-6082-388-A
Part No. Fixtur No.
GD-2038
5-4
Usage, Others Application, etc
For cleaning drum assembly and tape guide
For cleaning drum assembly
For cleaning tape guide
Tape path
Tape path (for tape top checking)
Tape path (for tape end checking)
Tape path (for checking)
For adjusting FWD/RVS back tension
For adjusting tape guide and reel table
For adjusting reel table
For adjusting tape guide
For adjusting tape guide
Tape path
Mechanism check and replacement
Electric tension regulator adjustment
Tape path