Ricoh SP 210 Setup Manual page 22

Configuring the IPv4 Address Settings Using the Smart Organizing
Monitor
On the [Start] menu, click [All Programs].
Click [Smart Organizing Monitor for SP xxx Series].
Click [Smart Organizing Monitor Status].
Click the [User Tools] tab.
Click [IP Address].
Enter the MAC address.
For the MAC address you need to enter, check the items on the configuration page. Depending on your
connection method, the item you need to check on the configuration page varies.
For Ethernet connection
‹
Interface Information
For wireless connection
‹
Wireless Status
Enter the IP address you want to change.
The computer's IP address can be ascertained using Command Prompt. To display the IP address, open
Command Prompt, enter "ipconfig", and then press the [Enter] key.
Enter the IP address of the computer being used with the variable part in the IP address modified.
Specify the subnet mask and default gateway address as required in accordance with the network environ‑
ment.
Click [OK].
If the configuration is successful, the message "IP Address has been set well." appears.
If the configuration fails, the message "Setting IP Address failed. Try again." appears. If this happens,
repeat the procedure from Step 6.
Click [OK].
Click [Close].
22