System Programming; Entering System Programming; Default Reset - Scytek electronic G5.2W SERIES Product Manual

Vehicle security system with remote start

Hide thumbs Also See for G5.2W SERIES:

Product manual (36 pages)

Table Of Contents

Table of Contents

Entering System Programming

This system is compatible with both the LCD two way transmitter or the standard transmitter, all system

programming can be performed using either one.

To enter System Programming using standard 5 button remote:

1. Turn the ignition switch to the ON position.

2. Within 5 seconds, press the valet switch 5 times.

· The siren/horn will provide three chirps/honks, indicating that you have entered Programming.

3. Press the valet switch the number times equal to the System Parameter you want to change.

· The siren/horn will chirp/honk each time the valet switch is pressed.

4. Within 5 seconds, press the transmitter button corresponding to the desired operating mode for

that System Parameter.

· The siren/horn will chirp/honk to indicate the setting.

1 chirp/honk

2 chirps/honks

3 chirps/honks

5. When you are finished, turn off the ignition to save the changes.

To enter System Programming using one button button remote:

1. Turn the ignition switch to the ON position.

2. Within 5 seconds, press the valet switch 5 times.

· The siren/horn will provide three chirps/honks, indicating that you have entered Programming.

3. Press the valet switch the number times equal to the System Parameter you want to change.

· The siren/horn will chirp/honk each time the valet switch is pressed.

4. Within 5 seconds, press the transmitter button once

· This siren/horn will chirp

Press the valet switch the number times equal to the desired operating system option.

· The siren/horn will chirp/honk to indicate the setting.

1 chirp/honk

2 chirps/honks

3 chirps/honks

5. When you are finished, turn off the ignition to save the changes.

Default Reset

Following this procedure will set all System Programming Parameters to factory default settings.

1. Enter System Programming.

2. Press Transmitter Button 3.

· The siren/horn will chirp/honk 6 times indicating that the reset signal was received.

· All System Programming parameters are now set to factory default settings.

· The Valet Mode is off.

3. Turn off ignition.