Scytek electronic Galaxy 5000RS PLUS SERIES Product Manual
Vehicle security system with remote start
Hide thumbs
Also See for Galaxy 5000RS PLUS SERIES:
- Product manual (36 pages) ,
- Product manual (32 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Scytek electronic Galaxy 5000RS PLUS SERIES
Summary of Contents for Scytek electronic Galaxy 5000RS PLUS SERIES
- Page 1 5000RS P P LUS S S ERIES VEHICLE SECURITY SYSTEM WITH REMOTE START PRODUCT MANUAL...
- Page 2 Limited L L ifetime W W arranty This vehicle security system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
-
Page 3: Table Of Contents
About Your System ............Page 1 Remote Transmitters . -
Page 5: About Your System
The ScyTek Galaxy 5000RS Plus is a combination vehicle security and remote starting system featuring a built-in "ScyNet Network Port" that allows direct connection of optional accessory modules and a PC interface offering expanded system operation. protection and performance for many years to come. The Galaxy 5000RS Plus’... -
Page 6: Remote Transmitters
Standard Remote Transmitter Description Button 1 Button 3 The Galaxy 5000RS Plus is supplied with two 5-button Remote Transmitters used to control system operations. Note: Using the optional PC or Pocket PC interface with the network software, it is possible to reconfigure the functionality of the transmitter buttons. -
Page 7: Two Car Operation
Adding/Replacing Transmitters To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired transmitters ready and follow the steps below. Note: Up to 4 transmitters can be programmed to operate the system. To erase any previously stored transmitter codes, be sure to program all 4 transmitter memory locations. -
Page 8: Optional 2-Way Lcd Remote Transmitter Description
Optional 2-way LCD Remote Transmitter Description Button 1 The Galaxy 5000RS Plus is compatible with the optional 2-way LCD remote transmitter, offering increased range and confirmation of any activated features. Button 1 Arms and Disarms the system and when held for 2 seconds, activates the system’s Panic feature. Button 1 also locks/unlocks the doors when the system is in Valet Mode. -
Page 9: Lcd Transmitter Battery Replacement
LCD Transmitter Battery Replacement Your Galaxy Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time. Depending on the amount of use, the battery may last up to six months before it needs replacement. When the battery needs replacing, the system’s operating range will decrease, the LCD display will show only one of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery voltage drops below minimum. -
Page 10: System Operation
Remote Arming The system monitors 6 independent areas ( zones ) while armed: doors, hood, trunk, shock sensor, optional sensor input, and the network port for future expansion. To Arm the System: 1. Turn off the ignition. 2. Press Button 1. ·... -
Page 11: Tamper Alert
Tamper Alert If the system was triggered while away, the LED will flash to indicate which zone triggered the system after disarming and turning on the ignition. The LED indication will repeat 8 times. LED Flashes (60 seconds): 1 flash 2 flashes 3 flashes 4 flashes... -
Page 12: Panic Mode
Panic Mode In the event of an emergency the transmitter’s remote Panic feature can be used to instantly trigger the alarm. To activate the Panic Mode: 1. Press and hold Button 1 for 3 seconds. · The alarm will sound. ·... -
Page 13: Automatic Rearming
To set the Emergency Override Code: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. · The siren will provide one long chirp, indicating that you have entered Programming. 3. Press the valet switch 4 times. ·... -
Page 14: Remote Start Features
Remote Starting To Remote Start the System: 1. Be sure the system is not in Valet Mode. 2. Press and hold Button 4 for three seconds. · The parking lights will turn on. · The LED will flash rapidly. · The engine will start and run for the duration of its programmed Run Time.* ·... -
Page 15: Automatic Start Mode
Automatic Start Mode The Automatic Start Mode allows the vehicle to automatically start the vehicle every one or two hours and run for the preset Run Time. To turn on Auto Cold Starting: 1. Turn Ignition switch Off and wait for 3 seconds. 2. -
Page 16: Extended Features
Ignition Door Locking For added safety, the Ignition Door Locking feature allows vehicles equipped with power door lock systems to automatically lock the doors when the ignition is turned on. If a door is open when the ignition is turned on, the Ignition Door Locking feature is disabled to protect against locking the keys inside the vehicle. -
Page 17: System Installation
1. Thoroughly read and become familiar with the installation instructions before beginning the installation. 2. Review system contents: Main Unit Two 5-Button Remote Transmitters Siren Shock Sensor Harnesses 6-Pin starter harness • 20-Pin main harness • 4-Pin shock sensor harness •... -
Page 18: Mounting The Control Unit
Mounting the Control Unit The control unit must only be mounted in the interior of the vehicle. Do not mount the main unit in the engine compartment. Choose a mounting location that will not be easily accessible to a thief, and will not interfere with the operation of any vehicle components such as foot pedals, steering column, air vents, seat rails, etc. -
Page 19: System Wiring
6-Pin Starter Harness Pin 1 RED WIRE A: Main Power Input A (+). Connect to the battery or constant power wire at the ignition switch with a minimum 30 Amp supply. Remove the fuse until the installation is complete and all wiring is checked. -
Page 20: Plug-In Connectors
Pin 9 BLACK WIRE: Ground Input (-). The Black wire must connect to a solid chassis ground. Clean away any paint or dirt to insure the best possible ground. Pin 10 RED WIRE: Module Power Input (+). Connect to a constant source of +12V. Pin 11 VIOLET WIRE: Positive Door Input (+). -
Page 21: Jumper Settings
Jumper Selection Carefully separate the top and bottom halves of the main unit case. Once the cover is removed, the parking light polarity jumper will be visible next to the parking light relay. Set the jumper for the correct polarity output as described below, then reassembly the main unit case. -
Page 22: System Programming
Entering System Programming This system is compatible with both the optional LCD transmitter or the standard AM transmitter, all system programming can be performed using either one. To enter System Programming: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. ·... -
Page 23: Branch Table
Branch Feature 1. Arm Mode 2. Auto Rearming Mode 3. Arming Chirps 4. Ignition Door Locking 5. Ignition Door Unlocking 6. Door Unlock Pulse 7. Door Lock Pulse Length 8. Passive Door Locking 9. Passive Arming Entry Delay 10. Ignore Open Door Report 11. - Page 24 10. Ignore Open Door Report. Bypasses the open zone warning chirps for vehicles equipped with a residual dome light circuit that remains on for a period of time after closing the door. 11. Aux 2 Auto Activate with Arm. When selected, the Auxiliary 2 output will activate when the system is armed.
-
Page 25: Real-Time Sensor Adjustment Mode
FM module must be connected before completing this step. FM Remote Learn. Learns the optional 2-way FM transmitter. Press Button 2 on the 1-way remote to enter FM Transmitter learn mode, then press transmitter Button 1 on each FM remote (max 2). *Requires the optional ScyNet FM LCD Pager Module. -
Page 26: Wiring Diagrams
Positive Dome Light TO POSITIVE DOME LIGHT Black/White (-) DOME LIGHT OUTPUT Positive Horn Honk TO POSITIVE HORN WIRE Brown/White (-) HORN OUTPUT Negative Glow Plug +12V (-) GLOW PLUG WIRE FROM VEHICLE Blue/Yellow Wire (+) GLOW PLUG INPUT Page 22 - Galaxy 5000RS Plus Wiring D D iagrams Black/White (-) DOME LIGHT... -
Page 27: Door Lock Diagrams
Door L L ock D D iagrams Follow the diagrams below for connecting basic door lock systems. For Two Stage door lock systems (separately unlocks driver and passenger doors) see following pages. Negative Trigger Positive Trigger Reverse Polarity Vacuum Adding Actuators Galaxy 5000RS Plus - Page 23... -
Page 28: Two Stage Door Lock Diagrams
Two S S tage D D oor L L ock D D iagrams The Galaxy 5000RS Plus is equipped with a dedicated Passenger Unlock output allowing Two Stage Door Lock operation. When connected as shown below, disarming the system will unlock only the driver’s door. - Page 29 Two S S tage D D oor L L ock D D iagrams c c ont’d Two Stage Reverse Polarity Two Stage Adding Actuators Galaxy 5000RS Plus - Page 25...
-
Page 30: Technical Information
FCC ID: OARRXAM2000 This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation Starter doesn’t start and Side Lights flash: 3 Times -... - Page 31 Notes Galaxy 5000RS Plus - Page 27...
-
Page 32: Wiring Diagram
Wiring D D iagram ScyTek Electronics 11627 Cantara Street Unit B North Hollywood, CA 91605 © ScyTek Electronics 2003 Galaxy 5000RS r3 11/03...