Related Manuals for Scytek electronic ASTRA 70000000
Summary of Contents for Scytek electronic ASTRA 70000000
- Page 1 ASTRA 7E7 WITH SEPERATE LOCK/UNLOCK BUTTONS VEHICLE SECURITY SYSTEM PRODUCT MANUAL...
- Page 2 Limited Lifetime Warranty This vehicle security system is warranted to the original purchaser, to be free from defects in material and workmanship. The manufacturer will repair or replace at its option, and free of charge for the first twelve (12) months, any part that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to the manufacturer freight prepaid.
-
Page 3: Table Of Contents
About Your System ............Page 1 2-way LCD Remote Transmitters . -
Page 5: About Your System
Congratulations on your purchase of this State-of-the-Art Vehicle Security System from ScyTek Electronics. With proper installation this system will provide superior protection and performance for many years to come. System Contents: Main Unit • One 5-Button 2-Way LCD Remote Transmitter •... -
Page 6: Way Lcd Remote Transmitters
2-way LCD Remote Transmitter Description Button 1 The Astra’s 7E7 2-way LCD remote transmitter is offering increased range and confirmation of any activated feature. Page 1 Button 1 Arms and Locks* the system and when held for 5 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode. -
Page 7: Battery Replacement
LCD Transmitter Battery Replacement Your Astra Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time. Depending on the amount of use, the battery may last up to three months before it needs replacement. When the battery needs replacing, the system’s operating range will decrease, the LCD display will show only one of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery voltage drops below minimum. -
Page 8: Lcd Backlight
To disable the auto activate function: 1. Press and hold Buttons 2 and 3 until the remote beeps four times. · The fan and clock will be shown indicating timer is activated. 2. Press Button 1 to disable the timer. ·... -
Page 9: Icon Descriptions
VLT Valet mode function sets and resets the security system valet mode. * this function is enabled only when the security system is disarmed Set or reset the Valet mode: 1. Press and hold Button 6 until the display shows VLT. ·... -
Page 10: Remote Transmitters
Remote Transmitter Description Button 1 Button 3 The Astra 7E7 is supplied with one 5-button Remote Transmitter used to control system operations. Button 1 Arms the system and when held for 2 seconds, activates the system’s Panic feature. Button 1 also locks the doors when the system is in Valet Mode. Button 2 Disarms the system. -
Page 11: Adding/Replacing Transmitters
Adding/Replacing One-Way Transmitters To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired transmitters ready and follow the steps below. Note: Up to 4 transmitters can be programmed to operate the system. To erase any previously stored transmitter codes, be sure to program all 4 transmitter memory locations. -
Page 12: System Operation
Remote Arming The system monitors 4 independent areas ( zones ) while armed: doors, hood/trunk, shock sensor and optional sensor input. To Arm the System: 1. Turn off the ignition. 2. Press Button 1. · The siren will chirp once.* ·... -
Page 13: Tamper Alert
Tamper Alert If the system was triggered while away, the LED will flash to indicate which zone triggered the system after disarming and turning on the ignition. The LED indication will repeat 5 times. LED Flashes: 1 flash 2 flashes 3 flashes 4 flashes 5 flashes... -
Page 14: Panic Mode
Panic Mode In the event of an emergency the transmitter’s remote Panic feature can be used to instantly trigger the alarm. To activate the Panic Mode: 1. Press and hold Button 1 for 3 seconds. · The alarm will sound. ·... -
Page 15: Automatic Rearming
To Emergency Override the system using the code: 1. Follow steps 1-3 above. 2. Press the override switch a number of times equal to the Disarm code, and continue holding for 10 seconds on the last press. · The system will disarm. If the code is entered incorrectly, turn off the ignition and begin again. -
Page 16: Extended Features
Ignition Controlled Door Locks For added safety, the Ignition Door Locking feature allows vehicles equipped with power door lock systems to automatically lock the doors when the ignition is turned on, and unlock the doors after the ignition key is turned off. If a door is open when the ignition is turned on, the ignition locking feature is disabled to protect against locking the keys inside the vehicle. -
Page 17: System Installation
1. Thoroughly read and become familiar with the installation instructions before beginning the installation. 2. Review system contents: Main Unit One 5-Button One-Way Remote Transmitter One 5 Button Two-Way LCD Remote Transmitter Siren Shock Sensor Harnesses 14-Pin main harness • 4-Pin shock sensor harness •... -
Page 18: Mounting The Control Unit
Mounting the Control Unit The control unit must only be mounted in the interior of the vehicle. main unit in the engine compartment. Choose a mounting location that will not be easily accessible to a thief, and will not interfere with the operation of any vehicle components such as foot pedals, steering column, air vents, seat rails, etc. -
Page 19: System Wiring
14-Pin Main Harness Pin 1 RED WIRE: +12V Battery Input (15A Fuse). The RED wire must be connected to a clean source of continuous +12V power. Pin 2 WHITE WIRE: Parking Light Output (+/-) relay. Connect the White wire to the circuit that shows +12V or ground only when the parking lights are on and set the internal parking light relay jumper to the proper polarity. -
Page 20: Plug-In Connectors
Starter Defeat Connectors Using a volt/ohm meter locate the starter wire (normally a heavier gauge wire) at the ignition switch. This wire will show +12V only during cranking. When this wire is cut the vehicle will be unable to start. Locate the BROWN starter disable wire included with the wiring harness and cut in half. -
Page 21: System Programming
Entering System Programming To enter System Programming: 1. Turn on ignition. 2. Within 5 seconds, press the valet switch 5 times. · The siren will provide three chirps, indicating that you have entered Programming. 3. Press the valet switch the number times equal to the System Option you want to change. ·... - Page 22 6. Ignore Open Door Report. Bypasses the open zone warning chirps for vehicles equipped with a residual dome light circuit that remains on for a period of time after closing the door. 7. Auto Rearming Mode. When selected, the system will automatically re-arm 30 seconds after it is disarmed if the doors have not been opened.
-
Page 23: Branch Table
21. Smart Siren Mode. When Enabled works with Optional ScyTek MP3 Player Siren unit. 22. Internal Receiver Mode. When Disabled with 2-Way Pager mode, the internal receiver will be disabled automaticly when the 2-way pager antenna is plugged in. When enabled always, the internal receiver will never turn off. -
Page 24: Door Lock Diagrams
Door Lock Diagrams Follow the diagrams below for connecting basic door lock systems. For Two Stage door lock systems (separately unlocks driver and passenger doors) see following pages. Negative Trigger Positive Trigger Reverse Polarity Vacuum Adding Actuators Page 20 - Astra 7E7... -
Page 25: Two Stage Door Lock Diagrams
Two Stage Door Lock Diagrams The Astra 7E7 is equipped with a dedicated Passenger Unlock output allowing Two Stage Door Lock operation. When connected as shown below, disarming the system will unlock only the driver’s door. Pressing the disarm button again will unlock all doors. Two Stage Negative Trigger Two Stage Positive Trigger Astra 7E7 - Page 21... - Page 26 Two Stage Door Lock Diagrams cont’d Two Stage Reverse Polarity Two Stage Adding Actuators Page 22 - Astra 7E7...
-
Page 27: Technical Information
FCC ID: OARRXAM2000 This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference. 2) This device must accept any interference received, including interference that may cause undesired operation Valet/Emergency Override/Call Switch Technical Information... -
Page 28: Wiring Diagram
ASTRA 7E7 © ScyTek Electronics 2006 Wiring Diagram WHITE Unlock Relay 87A (N.C) GREEN Lock Relay 30 (Common) BLUE Unlock Relay 30 (Common) BROWN Lock Relay 87A (N.C) VIOLET Unlock/Unlock Relays 87 (N.O) ScyTek Electronics 11627 Cantara Street North Hollywood, CA 91605 www.scytek.net Astra 7E7 9/20/06...