Replace An Active Device - AT&T TL96371 User Manual

Bluetooth
Bluetooth setup

Replace an active device

If you already have 2 active devices on the device list and you want to
activate a different device, you must deactivate one of the 2 active devices.
To replace an active device:
1. Press MENU
in use.
2. Press CID or
press SELECT
CID
3. Press or
press SELECT
CID
4. Press or
want to activate without a D1: or D2: prefix, then
press OPTION
CID or DIR to highlight Connect, then press
5. Press
SELECT . The screen displays Only 2 devices can be ready
for connection and then a list of devices for deactivation.
CID
6. Press or
deactivated, then press
Phone A is deactivated and you hear a confirmation
tone. The screen then displays Connecting Cell Phone B
to the base...
7. Depending on your cell phone settings, you may
need to press a key on your cell phone to confirm
the connection. When the new device is successfully
activated and connected, the screen displays
Device connected. You hear a confirmation tone.
NOTE: When adding, removing, or replacing a Bluetooth device on the active devices list, all
connected devices are temporarily disconnected until the procedure is complete. It may take
up to 2 minutes to reconnect.
on the telephone base when it is not
DIR to highlight Bluetooth, then
.
DIR to highlight Device list, then
.
DIR to highlight the device you
.
DIR to highlight the device to be
NEXT . The screen displays Cell
26
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
DEVICE LIST
D1:Headset A
D2:Cel l Phone A
Cel l Phone B
BACK OPTION
DEACTIVATE
D1:Headset A
D2:Cel l Phone A
BACK NEXT
Connecting
Cel l Phone B
to the base...
DEVICE LIST
D1:Cel l Phone B
D2:Cel l Phone A
Headset A
BACK OPTION