California Energy Commission Battery Charging Testing Instructions - AT&T TL96371 User Manual

Appendix

California Energy Commission battery charging testing instructions

This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will
be disabled.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all cordless handsets
are plugged with charged batteries and out of the chargers before proceeding.
2. While you press and hold
the power outlet.
3. After about 20 seconds, release
The process takes up to one minute to complete. When the phone successfully enters the CEC
battery charging testing mode, all handsets
hear a confirmation tone.
When the phone fails to enter this mode, repeat the steps mentioned above.
Note: The telephone base will be powered up as normal if you fail to press
within two seconds in Step 3.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in. The
telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See page 124 for handset
registration instructions.
/HANDSET LOCATOR, plug the telephone base power adapter back to
/HANDSET LOCATOR and then press it again within two seconds.
147
display
Put handset on BASE to register. You
/HANDSET LOCATOR
BC