Push To Talk (Ptt) Intercom; Ptt Call To A Single Device - AT&T SynJ SB67108 User Manual

Handset operation

Push to talk (PTT) intercom

You can directly broadcast your voice to the speakerphone of any
extension. The extension you called can respond by pressing the INT
key to begin two-way communication. Up to five pairs of PTT calls can
be maintained at a time.

PTT call to a single device

1. When the handset is idle, press PTT.
2. Press DIR or CID
handset or base.
3. Press and hold PTT until your handset screen
shows PTT to: X:Handset X Release PTT key to
stop (X represents the extension number [1-0];
Handset X represents the default handset name),
PTT to: X:Deskset X Release PTT key to stop
(X represents the extension number [1-0],
Deskset X represents the deskset name), or or
PTT to: :Base Release PTT key to stop
*
the connection is made, both the caller and the
destination party hear two beeps.
4. Speak into the speakerphone while continuing to peak into the speakerphone while continuing to
hold down the PTT key. Your voice is broadcast to
the desired extension.
Release the PTT key after speaking. There is a three-second PTT wait
5.
state with -MUTE slowly flashing on the screen. During the PTT wait
state, if necessary, you can press and hold the PTT key to continue
speaking into the speakerphone.
The destination party can now respond (see Answer a PTT call on
6.
page 39).
NOTE: If the called handset or telephone base is on an intercom or outside call, your
handset sounds a busy signal and displays Busy.
to choose the desired choose the desired
X:Handset X Release PTT key to
Release PTT key to stop. When
while continuing to
38
PTT to:
1:Handset 1
Release PTT key
to stop
PTT to:
1:Handset 1
-MUTE