Bandwidth Classes And Filters; Configuring The Class Setup Screen; Figure 89 Media Bandwidth Management: Class Setup; Table 58 Media Bandwidth Management: Class Setup - ZyXEL Communications P-660W-Tx User Manual

Chapter 16 Media Bandwidth Management Advanced Setup

16.5.1 Bandwidth Classes and Filters

Use bandwidth classes and child-classes to allocate specific amounts of bandwidth capacity
(bandwidth budgets). Configure a bandwidth filter to define a bandwidth class (or child-class)
based on a specific application and/or subnet. Use the Class Configuration screen (see
Section 16.5 on page
bandwidth filter. You can configure up to one bandwidth filter per bandwidth class. You can
also configure bandwidth classes without bandwidth filters. However, it is recommended that
you configure child-classes with filters for any classes that you configure without filters. The
ZyXEL Device leaves the bandwidth budget allocated and unused for a class that does not
have a filter itself or child-classes with filters. View your configured bandwidth classes and
child-classes in the Class Setup screen (see
The total of the configured bandwidth budgets for child-classes cannot exceed the configured
bandwidth budget speed of the parent class.

16.5.2 Configuring the Class Setup Screen

The class setup screen displays the configured bandwidth classes by individual interface.
Select an interface and click the buttons to perform the actions described next. Click "+" to
expand the class tree or click "-"to collapse the class tree. Each interface has a permanent root
class. The bandwidth budget of the root class is equal to the speed you configured on the
interface (see
child-class layers for the root class.
To add or delete child classes on an interface, click Media Bandwidth Management, then
Class Setup. The screen appears as shown (with example classes).

Figure 89 Media Bandwidth Management: Class Setup

The following table describes the labels in this screen.

Table 58 Media Bandwidth Management: Class Setup

LABEL
Interface
Back
Add Child-Class
Edit
164
163) to set up a bandwidth class's name, bandwidth allotment, and
Section 16.4 on page 160
DESCRIPTION
Select an interface from the drop-down list box for which you wish to set up classes.
Click Back to go to the main Media Bandwidth Management screen.
Click Add Child-class to add a sub-class.
Click Edit to configure the selected class. You cannot edit the root class.
Section 16.5 on page 163
to configure the speed of the interface). Configure
for details).
P-660W-Tx v2 User's Guide