Safety Precautions And Tips - Keys Fitness bicylce Owner's Manual

Safety Precautions and Tips

It is the owner's responsibility to ensure that all users
of this exercise bike have read the Owner's Manual and
are familiar with warnings and safety precautions.
• This exercise bike has a maximum user capacity of
300 pounds.
• The AirBike should only be used on a level surface and is
intended for indoor use only. It should not be placed in a
garage, patio or near water. Keys Fitness recommends an
equipment mat be placed under the bicycle to protect the
floor or carpet and for easier cleaning.
• Wear comfortable, good-quality walking or running shoes
and appropriate clothing. Do not use this exercise bike with
bare feet, sandals, socks or stockings!
• Always examine your exercise bike before using to ensure
all parts are in working order.
• Do not leave children unsupervised near or on the
exercise bicycle.
• Never operate the exercise bicycle where oxygen is being
administered or where aerosol products are being used.
• Never insert any object or body parts into any opening.
• Service to your AirBike should only be performed by an
authorized service representative, unless authorized and/or
instructed by a Keys Fitness technician. Failure to follow
these instructions will void the warranty.
2
Assembly of the AirBike
REMOVE ALL SECURITY TAPE AND
WRAPPING BEFORE BEGINNING.
1. Attach front stabilizer bar (16) and rear stabilizer bar (3) to
the frame by using the bolts (17), washers (12, 13) and cap
nuts (15) provided. Please note that the center distance
between the two screw holes of the front stabilzer bar is
longer than the center distance between the two screw holes
of the front stablizer bar is longer than the center distance
between the two screw holes of the rear stabilizer bar.
2. Attach pedals (14). Axles of pedals are branded "L" and "R".
The pedal marked "R" goes on the right hand side of the bike
and the one marked "L" on the left hand side. Tighten each
pedal by turning bolt towards the front of the bike. (Tighten
the left pedal bolt counter-clockwise and the right pedal bolt
clockwise.)
3. Mount the saddle (No.1) to the seat post (2). Level the saddle
then fasten the nuts and both sides of the saddle.
4. Adjust the height of the seat post according to your require-
ments by using the quick release seat knob (4)
5. Using the cord provided, tie to the computer cable (9) and pull
up throught the head stem (10) then untie the cord. Connect
the computer cable in the console tube to the computer cable
in the main frame.
6. Insert the head stem onto the frame. Secure in position with
bolts (11) and washers (12, 13) provided.
3