Receiver Operation; Getting Started; Tuning Control And Volume Control - Kenwood TH-78A Instruction Manual

1 Getting Started

Connect the battery pack and the supplied antenna.
Press the POWER switch to turn the transceiver on.
One of the default frequencies should appear on the
display.
If the display shows incomplete data, or you think the
displayed frequency is wrong, reset the micro-
processor Memory Initialization (see page 19)
10

RECEIVER OPERATION

2 Tuning Control and Volume Control

This transceiver assigns two volume and tuning
control functions to the two controls.
Before proceeding to the next step, master these
functions. The default setting is as follows:
dissappear
-after 2
seconds
Functions as the
volume control for
the UHF band.
Functions as the
tuning control for
the UHF band.