Replacing Fuses; Operation Panel And Microphone Connection - Kenwood TM-D710A Instruction Manual

REPlAcINg FuSES

If the fuse blows, determine the cause, then correct the problem. After the
problem is resolved, replace the fuse. If newly installed fuses continue to blow,
disconnect the power cable and contact your authorized Kenwood dealer or an
authorized Kenwood service center for assistance.
Fuse Location
Transceiver
(located on the DC connector)
Supplied DC power cable
Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.
Fuse holder (E type)

OPERATION PANEl ANd MIcROPhONE cONNEcTION

Plug the microphone plug to the MIC jack, then connect the Operation panel to
the TX/ RX unit with the supplied cable.
• Attach the microphone hanger to an appropriate position using the screws included in
the screw set.
Microphone
MIC jack
Modular plug cable
6
Fuse
Fuse holder
TX/ RX unit
Line filter
Line filter
Fuse Current Rating
5 A
20 A
Fuse holder (K, M4 types)
Fuse holder
Installing the Line Filter
Install the line filter
approximately 3 cm from the
connector.
Approx. 3 cm
Panel jack
Operation panel
Fuse