Nicd Battery Pack (Pb-13); Recharging; Installing The Battery Pack - Kenwood TH-78A Instruction Manual

144/430, 144/440 fm dual banders
Hide thumbs Also See for TH-78A:
Table of Contents

Advertisement

1 NiCd Battery Pack (PB-13)

You must charge the battery before you can use it.
It has not been charged at the factory in order to
provide you with the greatest number of charge/
discharge cycles. It takes several charge/discharge
cycles before the battery pack will operate for its
maximum period. If you store the battery pack for
more than two months, recharge it before use.

2 Recharging

Insert the charge plug from the charger (BC-14) into
the terminal on the top of the transceiver. Then
plug the charger into the AC line. Do not allow the
battery to charge for greater than 15 hours. The
useful life and battery performance will be reduced if
you exceed the recommended charge period.
(Illustrations show the U.S.A. version.)
8
THE
Recharging should be done within an ambient
104°F). Recharging performed out of this range
may not fully charge the battery.

3 Installing The Battery Pack

Insert the battery pack into the transceiver until it
locks in place.
To remove the battery pack slide the Release button
to the right and pull the pack down.
RELEASE button
,
,
.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Th-78eTh-78

Table of Contents