UPS System Installation
4.6
Installing Interface Connections
4.6.1 Installing Building Alarm Connections
To install wiring:
1.
Verify the UPS system is turned off and all power sources are removed. See Chapter 6, "UPS Operating
Instructions, " for shutdown instructions.
2.
To locate the appropriate terminals and review the wiring and termination requirements, see
paragraph 3.2.3, Table 4-1, Figure 4-2and Figure 4-3.
Wiring Access
4-6
Eaton 93E UPS (300/400 kVA, 380/400/415V) Installation and Operation Manual
Mini-Slot Communication Bays 1
Building Alarm
REPO Terminals
(See Figure 4-7 for detail)
Mini-Slot Communication Bays 2
Pull chain Terminals
CAN communication line
Figure 4-3. Interface Terminal Locations
Front middle cover plate
Pull chain hole 1
Pull chain hole 2
Remove the cover plate
Pull chain