Inspecting And Unpacking The Ups Cabinets - Eaton 93E Operation Manual

3.3

Inspecting and Unpacking the UPS Cabinets

The cabinet is shipped bolted to a wooden pallet and protected with an outer wood container.
The UPS cabinet is heavy (see Table 3-1). If unpacking and unloading instructions are not closely
followed, the cabinet may tip and cause serious injury.
1. Carefully inspect the outer packaging for evidence of damage during transit.
Do not install a damaged cabinet. Report any damage to the carrier and contact an
Eaton service representative immediately.
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinets using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see Figure 3-3 for the UPS cabinet centre of gravity
measurements).
Do not tilt the UPS cabinets more than 15° from vertical or the cabinets may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4. Remove the protective wood container from the cabinet:
a.
b.
c.
5. Remove the inner protective packaging.
6. Recycle the remainder of the outer shipping container and the inner protective packaging in a responsible
manner.
7 . Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
For the following step, verify that the forklift or pallet jack is rated to handle the weight of
NOTE
the cabinet (see Table 3-1 for cabinet weight).
NOTE
For the following steps, use pincer type pliers or a large flat blade screw driver to
straighten the securing tabs.
Straighten the tabs securing the top panel of the wooden container to the side panels of the
container.
Remove the top panel .
Straighten the tongues of the wooden plates and remove all the wooden plates
NOTE
While waiting for installation, protect the unpacked cabinet from moisture, dust, and
other harmful contaminants. Failure to store and protect the UPS properly may void
your warranty.
WARNING
CAUTION
CAUTION
Eaton 93E UPS (300/400 kVA, 380/400/415V) Installation and Operation Manual
UPS Installation Plan and Unpacking
3-11