Printer Communication Error Messages; Remove Paper From Standard Output Bin; Standard Network Software Error - Lexmark MS310 Series Service Manual

Remove paper from standard output bin

Do the following:
1
Remove the paper stack from the standard output bin.
2
From the printer control panel, press

Printer communication error messages

Network [x] software error [54]
Try one or more of the following:
• From the printer control panel, press
•
Unplug the router, then wait for 30 seconds, and then plug the router back again.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or print server. For more information, contact customer support.

Standard network software error [54]

Try one or more of the following:
•
From the printer control panel, press
• Turn off the printer, and then turn it back on.
•
Update the network firmware in the printer or on the print server. For more information, contact customer support.
Standard parallel port disabled [56]
Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the parallel port.
• Set the Parallel Buffer to Auto.
–
If the printer is on a network, then access the Embedded Web Server.
1
Open a Web browser, and then type the printer IP address in the address field.
Notes:
•
Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
• If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2
Click Settings > Network/Ports > Parallel.
3
In the Parallel Buffer field, enter 2.
4
Click Submit.
– If the printer is connected to a computer by a USB or parallel cable, then access the Parallel menu through the
Local Printer Settings Utility for Windows or through Printer Settings for Macintosh.
to continue printing.
to continue printing.
to continue printing.
to continue printing.
Diagnostic information
46
4514-220, -230