Auto Lf After Cr; Energy Conserve; Wipe All Settings; Font Density - Lexmark MS310 Series Service Manual

Auto LF after CR

This is used to select whether or not the printer automatically performs a line feed after a carriage return control
command. The Auto LF after CR is common to both the PPDS and PCL emulations. When the setting is changed, it is
changed for both emulations.
Available options:
•
Off
• On

Energy Conserve

This affects the values that appear in the Power saver setting in General settings menu.
Available options:
• Off—The Power saver menu displays a Disabled setting. When selected, it disables the Power saver feature.
•
On—Disabled does not appear in the Power saver menu. The user cannot disable the Power saver feature.

Wipe All Settings

This makes any sensitive information that may exist on the volatile or non-volatile storage of the device completely
indecipherable. When selected, the printer performs a non‑critical NVRAM reset and then reboots.

Font Density

This creates microscopic holes in all black text. The holes save toner by reducing overlapping toner.
Available options: 1 to 5

Font Sharpening

This allows a user to set a text point-size value below which the high‑frequency screens will be used when printing font
data.
Available options:
•
Off
•
On

Parallel Protocol

This printer supports both the standard and the fastbytes parallel handshaking protocols.
Available options:
•
Standard—The printer can receive information at a normal transmission rate.
•
Fastbytes—The printer can receive information at a much faster transmission rate, provided that the host computer
also supports the fastbytes protocol.
Service menus
122
4514-220, -230