Connection On The Transceiver Unit; Power Cable; Antenna Coupler Cable - Furuno FS-1570 Installation Manual

2.1.2

Connection on the transceiver unit

Power cable

Cut the rubber bush to the form of cross with knife.
Pass the power cable (supplied) through the hole at the bottom of the transducer unit, and
fasten it to the TB1 and 2. Fasten it to the fixing plate at cable entrance with a cable tie
(local supply.) When connecting to the optional AC-DC power supply unit PR-300 (FS-1570)
or 850A (FS-2570), supply AC power and DC power to the PR-300/850A. See paragraph
"2.3 Connection of AC-DC Power Supply Unit" for detail.

Antenna coupler cable

Cut the rubber bush to the form of cross with knife.
Cut the connector of the signal cable (05S0949) off, pass the cable to the rubber bush, and
then connect the cable to TB5 on the T-IF Board (05P0731) (See Note 1.). Wrap vinyl tape
or attach an insulating tube to the shield wire to prevent the shorting to the board. Fasten
the signal cable to the fixing plate with a cable tie (local supply.)
Attach the M-type connector of the coaxial cable 05S0462, from the antenna coupler) to T/R
ANT port. Note that when running the coaxial cable, attach it with slack for opening/closing
the lid.
05S0462
Cable from Antenna Coupler
TB5
BRW
I ANT
TUNE OK RED
THROUGH
ORG
YEL
TUNE
GRN
DUMMY
WHT
+ 15V
BLK
0V
SHIELD
1 2 3 4 5 6 7 8
COUPLER
05P0731
TB1(+) TB2(-)
FV5.5-4
YELLOW 2 pcs.
DPYC-6 (FS-1570) or
DPYC-10 (FS-2570)
T-IF Board (FS-1570)
Connection of transceiver unit
1
2
3
4
5
6
7
8
9 10 111213 141516
171819 2021222324
252627282930 3132
9 mm
05S0949
2-3