Mercedes-Benz COMAND Operating Instructions Manual page 73

Select From Last Destinations From Last Destinations
X
press W to confirm.
Select the desired destination by turning
X
cVd the COMAND controller and press W
to confirm.
The address entry menu appears again. The
destination address selected has been
entered.
To start route calculation: select
X
and press W to confirm.
Once the route has been calculated, route
guidance begins (
Y
i
"Last destinations" memory
( page 107).
Y
Entering a destination using the map
Calling up the map
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination Destination
X
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
and
Start Start
page 69).
in the navigation sys-
Destination entry
Current vehicle position
:
Crosshair
;
Details of the crosshair position
=
Map scale selected
?
Select Using Using Map Map and press W to confirm.
X
You will see the map with a crosshair.
Display = depends on the settings selected
in "Map information in the display"
( page 111). You can see the current street
Y
name if the digital map contains the neces-
sary data, You can see the coordinates of the
crosshair if the geo-coordinate display is
switched on and the GPS signal is strong
enough.
Moving the map and selecting the des-
tination
To scroll the map: slide XVY, ZVÆ or
X
aVb the COMAND controller.
To set the map scale: as soon as you turn
X
cVd the COMAND controller, the scale bar
appears.
Turn cVd until the desired scale is set.
X
Turning clockwise zooms out from the map;
turning counter-clockwise zooms in.
71
Z