Destination Memory; Entry As A Home Address - Mercedes-Benz COMAND Operating Instructions Manual

Recalculating the route dynamically
The route types Dynamic Route Dynamic Route
Dynamic Dynamic Route Route Only Only After
all relevant traffic messages into account
when calculating a route (
If you have selected Dynamic Route Dynamic Route
route type, COMAND guides you to your des-
tination along the updated route.
If you have selected Dynamic Route Only Dynamic Route Only
After Request After Request as the route type, a prompt
will appear first.
You can now decide whether to:
accept the route suggested by COMAND
R
continue your original route
R
To accept the suggested route: press W
X
the COMAND controller.
To continue along the original route:
X
select Reject Reject by turning cVd the
COMAND controller and press W to con-
firm.

Destination memory

Home address (My Address)
Entering the home address via address
entry
Proceed as described under "Adopting an
X
address book entry as a home address"
( page 103). Confirm
Y
pressing W.
To enter the home address for the first
X
time: confirm New Entry New Entry
and
After Request Request take
page 62).
Y
as the
My Address My Address by
by pressing W.
Destination memory
To change the home address: select
X
Change Change in the menu showing the home
address by turning cVd the COMAND con-
troller and press W to confirm.
Confirm New Entry New Entry
X
In both cases, enter the home address as a
X
destination, e.g. as a city, street and house
number ( page 64). Then, save the home
Y
address ( page 69).
Y
Adopting an address book entry as a
home address
To switch to navigation mode: press the
X
Ø button.
To show the menu: press W the COMAND
X
controller.
Select Destination Destination
X
tem menu bar by turning cVd the
COMAND controller and press W to con-
firm.
Select From Memory From Memory
X
firm.
You will see the destination memory list
either with the character bar (option 1) or
as a selection list (option 2).
Option 1: destination memory list with
character bar
Slide VZ the COMAND controller repeat-
X
edly until the destination memory list
appears as a selection list.
Option 2: destination memory list as
selection list
by pressing W.
in the navigation sys-
and press W to con-
Z
103