Mercedes-Benz COMAND Operating Instructions Manual page 121

this occurs, restart the update with the
engine running.
Insert the DVD ( page 196).
X
Y
COMAND checks whether the digital map
on the DVD is compatible with the naviga-
tion system and system software.
A prompt then appears asking if you want
to install the database. Versions of the
database currently installed and the data-
base that is to be installed are displayed.
Select Yes Yes or No No and press W to confirm.
X
After selecting Yes, an activation code Yes
must be entered when installing a database
for the first time. You will receive the acti-
vation code when you buy the navigation
DVD.
If you select No No, the process will be can-
celed.
Enter the activation code.
X
After entering the activation code cor-
rectly, COMAND starts updating the digital
map. Once the update is finished, you will
see a message.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
While the update is running, you will see a
message to this effect and a progress bar.
The navigation system is not operational
until the update is complete.
i
You cannot eject the DVD during the
update. If you switch off COMAND during
the update, the update is interrupted. It
then continues from where it was interrup-
ted when the system is restarted.
COMAND may prompt you to change the DVD
during the update.
Press the 8 load/eject button.
X
Take the DVD out of the slot.
X
Insert the requested DVD.
X
Once the update has been successfully
completed, you will see a message to this
effect.
Additional settings
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
The update is complete.
If the update is not successfully completed,
you will see a message that the map update
is not possible.
To confirm the message: press W the
X
COMAND controller.
Take the DVD out of the slot.
X
119
Z