Connecting The Ethernet Interface - Xerox Document Centre 400 series User Manual

2.2.2 Connecting the Ethernet interface

Connecting by the Ethernet interface will enable the following environments to be used:
• 100Base-TX
• 10Base-T
• 10Base-5
The procedure for connection by Ethernet interface is as follows:
When connecting connector for 10Base-5, follow the procedure on the next page and set
the value of Ethernet setting to 10Base-5. When connecting TX/T connector, also refer to
the procedure on next page and change the setting if you would like to fix the transmission
speed for 100Base-TX or 10Base-T.
After setting Ethernet, change the setting from the printer or host device, depending on the
environment setting that you are in.
100Base-TX and 10Base-T are set to switch automatically. When using 10Base-5
environment, be sure to set the Ethernet values from the printer control panel after
connecting the cable.
The Network Print Environment User Guide for the setting method.
2.2 Using the Ethernet Interface
Connect the interface cable to the Ethernet
interface connector.
Do not connect the interface cable to
the two Ethernet interface connectors
together as this will cause poor
transmission or breakdown.
For the interface cable, use the cable
suited to the network.
Switch on the power of the printer.
2
21