3.3
This section explains the two types of outputting:
• Forced outputting of remaining print data (see 3.3.1)
• Outputting all jobs in the printer (see 3.3.2)
3.3.1 Forced outputting of remaining print data
For the PCL 6 emulation mode, data will not be output until a full page of data is collected.
If the last piece of data ends at the middle of a page, it will wait for the next data until the
present Auto Eject Time has passed and "Data wait" will be shown on the display.
The operation of forcibly printing data in the printer without waiting for the Auto Eject
Time to pass in such instance is known as forced outputing.
The procedure is as follows:
Outputting
For parallel and serial interfaces, the next job sent when the display shows "Data
wait" might not be printed properly.
Send the next job after forced outputting or when Auto Eject Time is over.
"5.3 Common Menu Items" regarding Auto Eject Time.
When the display is at the state as shown on
the left, press
.
Printing will commence.
When printing is done, "Print/Fax Ready"
will be shown.
3
31