Memory-To-Vfo Transfer; Channel Display - Kenwood TM-D700 E Instruction Manual

MEMORY-TO-VFO TRANSFER

You may sometimes want to search for other stations or
a clear frequency, near the frequency stored in a
memory channel or the Call channel. In this case first
transfer the contents of a memory channel or the Call
channel to the VFO.
1 Recall the desired memory channel or the Call
channel.
2 Press [F], [Ms s s s s V].
7
• The entire contents of the memory channel or the Call
channel are copied to the VFO.
Note:
A transmit frequency from an odd-split memory channel or odd-split
Call channel is not transferred to the VFO. To transfer a transmit
frequency, press [REV], then press [F], [M s s s s s V].
Lockout status and memory names are not copied from a memory
channel to the VFO.
If you recall the Call channel in step 1, simply turning the Tuning
Control or pressing Mic [UP]/ [DWN] also transfers the contents to
the VFO. The frequency, however, is changed by one step.
40

CHANNEL DISPLAY

When in this mode, the transceiver displays only
memory channel numbers (and memory names if stored)
instead of frequencies.
1 Press [MNU] to enter Menu mode.
2 Press [c c c c c ]/ [d d d d d ] to select "RADIO (1–)", then press
[OK].
3 Press [c c c c c ]/ [d d d d d ] to select "MEMORY (1–4–)", then
press [OK].
4 Press [c c c c c ]/ [d d d d d ] to select "CHANNEL DISPLAY (1–4–
2)", then press [OK].
5 Press [c c c c c ]/ [d d d d d ] to switch the function ON (or OFF).
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
Note: You cannot switch this function ON unless you can recall any
channel on both bands A and B.
When in Channel Display mode, you cannot use the
following functions:
S u b b - a n d S e e l t c V F O S e
M e m o y r S o t e r P M S o t
M e m r o - y o t V - F O
P a t r a i / l
T a r n f s r e
/ 1 1 0 M H z S e t p C h a n g e A l l c - o n r t
e l t c V F O S c a n
e r P M R e c l l a
F e r q u e n y c S e t p
F u / l l P M R e s t e
C h a n g e
l o L o k c
S z i e