Selecting Scan Resume Method - Kenwood TM-D700 E Instruction Manual

144/440 mhz fm dual bander 144/430 mhz fm dual bander
Table of Contents

Advertisement

SELECTING SCAN RESUME METHOD

The transceiver stops scanning at a frequency (or
memory channel) on which a signal is detected. It then
continues scanning according to which resume mode
you select. You can choose one of the following modes.
The default is Time-operated mode.
Time-Operated mode
The transceiver remains on a busy frequency (or
memory channel) for approximately 5 seconds, and
then continues to scan even if the signal is still
present.
Carrier-Operated mode
The transceiver remains on a busy frequency (or
memory channel) until the signal drops out. There is
a 2 second delay between signal drop-out and scan
resumption.
Seek mode
The transceiver remains on a busy frequency (or
memory channel) even after the signal drops out and
does not automatically resume scanning.
Note: To temporarily stop scanning and monitor weak signals, press the
Mic PF key assigned the Monitor function {page 62}. Press the PF key
again to resume scanning.
1 Press [MNU] to enter Menu mode.
2 Press [c c c c c ]/ [d d d d d ] to select "RADIO (1–)", then press
[OK].
3 Press [c c c c c ]/ [d d d d d ] to select "AUX (1–9–)", then press
[OK].
4 Press [c c c c c ]/ [d d d d d ] to select "SCAN RESUME (1–9–1)",
then press [OK].
5 Press [c c c c c ]/ [d d d d d ] to select Time-Operated (default),
Carrier-Operated, or Seek.
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
9
49

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tm-d700aTm-d700eTm-d700ae

Table of Contents