Chapter 6 Operating Through Repeaters - Kenwood TM-D700 E Instruction Manual

Repeaters, which are often installed and maintained by
radio clubs, are usually located on mountain tops or
other elevated locations. Generally they operate at
higher ERP (Effective Radiated Power) than a typical
station. This combination of elevation and high ERP
allows communications over much greater distances
than communications without using repeaters.
6
Most repeaters use a receive and transmit frequency
pair with a standard or non-standard offset (odd-split). In
addition, some repeaters must receive a tone from the
transceiver to allow it to access. For details, consult
your local repeater reference.
TX: 144.725 MHz
TX tone: 88.5 Hz
RX: 145.325 MHz
28
OPERATING THROUGH REPEATERS
TX: 144.725 MHz
TX tone: 88.5 Hz
RX: 145.325 MHz
Offset Programming Flow
q
Select a band.
w
Select a receive frequency.
e
Select an offset direction.
r
Select an offset frequency.
(Only when programming odd-split
repeater frequencies)
t
Activate the Tone function.
(If necessary)
y
Select a tone frequency.
(If necessary)
If you store the above data in a memory channel, you
need not reprogram every time. See "MEMORY
CHANNELS" {page 35}.