Sony RCP-1500 Operation Manual page 72

Config menu
Item
Menu
V Detail Creation Mode
V Detail Control Mode
Test2 Mode
Chroma Filter
720P Acquisition
CCU GenLock Mode
Bars Character
Chroma
Return Settings
Channel ID
CCU Menu Control
RCP
RCP Assignment
Multi Format
3D System 3D Mode
Channel ID
3D CAM Control
72
Menus
Option Function
Select the generation method for V Detail.
RGB Nam Uses the V Detail generated from each of the R, G, and B channels that
has the largest amplitude. This increases resolution sensitivity, but S/N
sensitivity may deteriorate.
G Generates V Detail from the G channel.
R+G Generates V Detail from a signal combining R and G.
Y Generates V Detail from the luminance signal.
Sets control for when the Detail H/V Ratio knob is turned.
H/V Moves H Detail and V Detail in the opposite direction in response to
movement of the knob.
V Only Adjusts V Detail only.
Selects the signal of Test2.
3step Selects a convex test waveform.
10step Selects a step test waveform.
Sets the band for the chroma component. Full is the same band as the
signal standard, and the band becomes narrower above that.
Selects the 720P generation mode. This can only be set when a camera
with a switching function is connected.
Super Sampling This is 720P using the super sampling system.
V-SOP This is 720P using the V-SOP system.
Selects the type of signal using synchronization.
HD This is the HD3 value SYNC.
SD This is BBS.
Sets the characters to add to color bars signals.
On Add characters to color bars signals.
Edit Opens the character edit screen.
Turns OFF the VBS chroma signal.
Off Adds the chroma component to VBS.
– See "To set the return input settings" (page 76).
Sets the Channel ID display for direct output.
Channel ID ON Turns ON the Channel ID display for direct output.
– See "To control the CCU menu" (page 76).
See "RCP menu items" below.
Panel No. Selects the target cameras to be controlled by the control panel. This
can only be set when in MCS mode. In addition, all connected devices
must support the RCP assignment function.
Sets the video format for each CCU output.
3D Mode Turns ON/OFF the 3D Mode.
Sets the Channel ID display for direct output.
Channel ID ON Turns ON the Channel ID display for direct output.
Sets the camera to be controlled from the control panel in 3D System.
CAM Ctrl Sets the camera(s) to be controlled from the control panel: Left Camera,
Right Camera, or both.