Sony RCP-1500 Operation Manual page 59

Paint menu
Menu Submenu
Skin DTL 3
Matrix
User Matrix 1/2
User Matrix 2/2
Multi Matrix
Switch Control item
Skin DTL 3
Level
Phase
Width
Saturation
Auto Hue 3
Gate 3
ON
ON
R-G
G-B
B-R
ON
R-B
G-R
B-G
ON
Phase
Hue
Saturation
Gate
All Clear
Description
Sets the third channel of Skin DTL.
Enables Skin DTL of this channel. When this channel is enabled, the ON
mark appears on the very left of the tab.
This is the contour correction value within the color area that is set with
Phase or Width. Adjusting this in the plus direction makes pictures sharp,
and adjusting this in the minus direction makes pictures soft. For cameras
with an electronic software focus function, this enables softer pictures than
when in the DTL OFF state.
Adjusts the center of the hues of the effective color area of Skin DTL. The
value is almost equivalent to the phase on a vector scope.
Sets a range centered on the phase. The value indicates an angle.
Disables Skin DTL for places with a small degree of color saturation.
Adjusting this in the minus direction also allows Skin DTL to be enabled for
places with less saturation.
This is a function for automatically searching for a hue. Capture the subject
you want to measure in the center of the screen and execute the function.
The phase of this channel is adjusted automatically.
Adds a gate signal to the range of this channel for which Skin DTL is
effective. For the output connector for which the signal can be added, refer
to the manual of the corresponding device.
Corrects the color reproduction without changing the white balance.
Enables the matrix function. This switch enables the function to be turned
ON/OFF simultaneously in accordance with individual matrix settings.
Sets the matrix correction factor individually. This is the first page of the
settings. When User Matrix is enabled, the ON mark appears on the very
left of the tab.
Enables the User Matrix function.
Corrects the signal of the R channel in accordance with the difference
between the signals of the R channel and G channel.
Corrects the signal of the G channel in accordance with the difference
between the signals of the G channel and B channel.
Corrects the signal of the B channel in accordance with the difference
between the signals of the B channel and R channel.
Sets the matrix correction factor individually. This is the second page of the
settings. When User Matrix is enabled, the ON mark appears on the very
left of the 1/2 tab.
Enables the User Matrix function. This is the same switch as 1/2.
Corrects the signal of the R channel in accordance with the difference
between the signals of the R channel and B channel.
Corrects the signal of the G channel in accordance with the difference
between the signals of the G channel and R channel.
Corrects the signal of the B channel in accordance with the difference
between the signals of the B channel and G channel.
Changes color reproduction for each hue divided into 16. When Multi
Matrix is enabled, the ON mark appears on the very left of the tab.
Enables the Multi Matrix function.
Selects the hue to adjust.
Changes the hue of colors within the hue range selected with Phase.
Changes the saturation of colors within the hue range selected with Phase.
Adds a gate signal to an image within the hue range selected with Phase.
For the output connector for which the signal can be added, see the
manual of the corresponding device.
Returns the factors of all ranges of Multi Matrix to their initial states.
59
Menus