Sony RCP-1500 Operation Manual page 43

The numeric keypad appears.
Security
Engineer Protection
Code No:
OK Cancel
2
Use the numeric keypad to enter "0359," and then
[OK]
press .
The Engineer Protection screen appears.
Engineer Protection
Code
Enable
Code
Delete
3
[Code Enable]
Press to light the button.
Security code protection is enabled.
[Code Delete]
If you press
confirmation screen for security code deletion appears.
The Engineer Protection screen reappears when you
[OK]
press .
4
[Exit]
Press .
To set the security code
Some of the menus on the control panel are operated in
engineer mode. To limit the use of engineer mode to specific
operators, preset the security code. After you set the security
code, it will need to be entered to switch to engineer mode.
1
Enter engineer mode. (page 52)
Security
Page Item
Permission Permission Change
ALL
Preset
Exit
7 8 9
4 5 6
1 2 3
0
Exit
here to light the button, a
Exit
Code
Engeneer
Mode
2
[Code Change]
Press .
The numeric keypad and new security code (Code No.)
input field appear.
Security
Engineer Mode
Code No:
OK Cancel
3
Use the numeric keypad to enter any security code (1
to 8 digits), and then press
Note
Each number entered for the security code appears as "*"
on the screen.
A security code reentry screen appears.
4
Confirm the security code entered in step 3 by
reentering it, and press
The Security screen reappears.
5
[Engineer Mode]
Press
The security code is set, and the numeric keypad will
appear whenever you press the
in the Security screen. To enter engineer mode, enter the
security code that was set and press the
To change the security code
1
Perform steps 1 to 4 of "To enter engineer mode"
(page 52) to display the Security screen.
2
[Engineer Mode]
Press .
The numeric keypad and security code (Code No.) input
field appear.
Security
Engineer Mode
Code No:
OK Cancel
3
Enter the security code, and then press
Note
Each number entered for the security code appears as "*"
on the screen.
The control panel enters engineer mode, and
Change]
appears.
Exit
7 8 9
4 5 6
1 2 3
0
[OK]
.
[OK]
.
to cancel engineer mode.
[Engineer Mode]
button
[OK]
button.
Exit
7 8 9
4 5 6
1 2 3
0
[OK]
.
[Code
Settings
43