Sony RCP-1500 Operation Manual page 60

Paint menu
Menu Submenu
Preset Matrix
Gain
Gamma
Gamma
Step
Black Gamma
Knee
Knee Point
Knee Slope
Auto Knee
60
Menus
Switch Control item
ON
Preset Matrix
Step
M White
OFF
R/G/B
Master
Step Gamma
ON
Range
R/G/B
Master
OFF
R/G/B
Master
Knee Max
R/G/B
Master
ON
Adaptive
Point Limit
Auto Slope
Description
Selects the matrix provided for the camera in advance. When Preset Matrix
is enabled, the ON mark appears on the very left of the tab.
Enables Preset Matrix.
Selects the matrix provided for the camera in advance.
Sets is the sensitivity of the camera. The sensitivity of the camera is
determined by the sum of the master gain and the master white gain.
Changes the sensitivity of the camera in steps.
Changes the sensitivity of the camera continuously.
Corrects the photoelectric conversion characteristic of the image pickup
device to the luminance characteristic of the display.
Disables the gamma correction function.
Adjusts the correction level of each of R, G, and B.
Links R, G, and B and adjusts them simultaneously.
Changes correction in steps.
Adjusts gamma correction of the screen dark sections.
Enables the black gamma function.
Selects the range for which black gamma is effective. Select from Low
Range, L.Mid Range, H.Mid Range, and High Range.
Adjusts the correction level of each of R, G, and B.
Links R, G, and B and adjusts them simultaneously.
Compresses the bright parts of the screen to enable expressions within the
signal standard. This enables you to obtain pictures that have a high
dynamic range.
Disables knee correction. Auto Knee is also disabled.
Compresses the bright parts and adjusts the start level.
Adjusts the level of each of R, G, and B.
Links R, G, and B and adjusts them simultaneously.
Applies clipping at the point that knee correction is applied to make
adjusting the knee point easy. This can only be set when in engineer mode
or when Knee Max Enable is enabled.
Adjusts the ratio for compressing images.
Adjusts the compression level of each of R, G, and B.
Links R, G, and B and adjusts them simultaneously.
Automatically adjusts the knee factor in accordance with the captured
image signal.
Enables the auto knee function. The settings configured for Knee Point/
Slope are ignored. When auto knee is enabled, the ON mark appears on
the very left of the tab.
Divides the area with knee applied in the level direction, and sets the
optimal slope for each part.
Sets the lower limit for the knee point automatically adjusted by auto knee.
This results in low level images not being influenced by auto knee.
Sets the knee slope of auto knee.