Sony RCP-1500 Operation Manual page 68

Maintenance menu
Menu Secondary
menu
CCU
Phase
Monitor Output
3D Monitor
SD Adj
SD Detail
68
Menus
Submenu Switch
H
SC
4:3 Marker
4:3 Mod
Select
Mode
CAM Ctrl
OFF
1/3
Control item Description
These are the maintenance items related to the CCU.
When a synchronization signal is input to the CCU, this allows
you to set the phase in relation to that signal.
Sets the phase of H.
H Step Adjusts the phase of the H direction.
H Course Coarsely adjusts the phase of the H direction.
H Fine Finely adjusts the phase of the H direction. This can only be
used when an SD camera is connected.
Adjusts the phase of the subcarrier.
SC Phase Adjusts the phase of the VBS subcarrier.
BF Phase Adjusts the phase of the burst flag. This can only be used when
an SD camera is connected.
Sets the marker for monitor output.
Places a 4:3 marker on a 16:9 image for monitor output of the
CCU.
Gate Marker Sets the brightness of the gate marker (skin gate, etc.).
Darkens the outside of a 4:3 area within an 16:9 image for
monitor output of the CCU.
Moduration This is the level with which to darken with 4:3 Mod.
Level
Sets the 3D Monitor output of the CCU.
Select Left Camera, Right Camera or 3D Monitor for the 3D
Monitor output.
Sets the display mode during the 3D Monitor output setting.
Border Line Sets whether to display the border lines when the 3D Monitor
Mode is set to split mode.
Sets the camera(s) to be controlled from the control panel: Left
Camera, Right Camera, or both.
These are the maintenance items for down converter output.
This is the contour correction function for down converter output.
Disables the SD Detail function.
This is the first page of SD Detail adjustment.
Level This the contour correction level. Adjusting this in the plus
direction makes pictures sharp, and adjusting this in the minus
direction makes pictures soft.
Limiter Makes adjustments so that contour correction is not greater than
a set level to prevent overcorrection by strong contour correction
when shooting subjects with large luminance differences.
Adjusting this in the plus direction also enables clipping of
objects with small luminance differences.
Crisp Makes adjustments so that signals with small luminance
differences are considered to be noise and correction is not
applied to them in order to reduce the emphasizing of also the
contours of noise by the contour correction function. Adjusting
this in the plus direction results in luminance differences for
which contour correction is not performed becoming large and
improvements in S/N sensitivity, but resolution sensitivity
deteriorates.
Level Dep Contour correction is not applied to the dark parts and S/N
sensitivity is increased in order to reduce the emphasizing of
also the contours of noise by the contour correction function.
Adjusting this in the plus direction results in contour correction
not being applied up to a brighter level.