Kenwood Excelon KVT-911DVD Instruction Manual page 63

Removing Monitor Unit
■
Removing the Hard Rubber Frame
1
Engage the catch pins on the removal tool and remove
the two locks on the lower level.
Lower the frame and pull it forward as shown in the
figure.
2
When the lower level is removed, remove the upper two
locations.
NOTE
The frame can be removed from the top side in the same
manner.
■
Removing the Unit
1
Refer to the section "Removing the Hard Rubber Frame" and then
remove the hard rubber frame.
2
Remove the Hex-head screw with integral washer (M4×6) on the
back panel.
3
Insert the two removal tools deeply into the slots on each side, as
shown.
4
Lower the removal tool toward the bottom, and pull out the unit
halfway while pressing towards the inside.
2 CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the way out with your hands, being careful not to
drop it.
Catch
Lock
Accessory J
Catch facing up
63