Panasonic KX-TS620CB Operating Instructions Manual page 18

Preparing the Answering System
4
When finished, press {STOP}.
• After a few seconds, the display will change.
Greeting message sample
"Hello, this is (your name and/or number). Sorry I cannot take your call. Please leave a
message after the beep. Thank you."
• If the unit starts to ring while recording a greeting message, press {SP-PHONE/
HEADSET} or lift the handset off the unit to answer the call. The recording will stop.
Start again from the beginning after hanging up.
To check the recorded greeting message
Press {GREETING CHECK}.
• The greeting message will be played.
To erase the recorded greeting message
Press {GREETING CHECK}, and then press {ERASE} while the message is
being played.
• The unit will answer a call with a pre-recorded greeting.
Pre-recorded greeting message
If you do not record a greeting message (p. 17), one of two messages will be
played when a call is received, depending on the caller's recording time (p. 21).
To check the pre-recorded greeting, press {GREETING CHECK}.
A pre-recorded greeting will be played as follows:
∫ When the recording time is set to "1 minute", "2 minutes" or "3 minutes":
"Hello, we are not available now. Please leave your name and phone number after the beep.
We will return your call."
∫ When the recording time is set to "Greeting only":
"Hello, we are not available now. Please call again. Thank you for your call."
Flash Memory Message Backup
Messages are stored indefinitely on a "flash memory" IC chip and will not be
affected by power failures. All messages are saved until you erase them.
18