Nsa-2400 Login And Access; How To Reset The Nsa - ZyXEL Communications NSA-2400 User Manual

The disk drive ALM LED is on.
• The hard disk has a problem. What you have to do is turn the NSA-2400 off and replace
the faulty disk. See your Quick Start Guide for information on replacing a disk and also
Section 7.7.3 on page
Storage > Disk screen and click the Repair icon next to the new disk. If there is already
another volume resynchronizing, then you will see Waiting Resync as the volume status.
• If the problem continues, contact the vendor.
The LAN LED is off.
• Make sure the Ethernet cable is connected properly to the NSA-2400 and connected to
another (Ethernet) device. Make sure the other device is turned on. If it's connected
directly to a computer, make sure that the computer network card is working (ping
127.0.0.1 on the computer).
• Use another Ethernet cable. If you're connecting to a Gigabit Ethernet, make sure you're
using an 8-wire Ethernet cable.
• If the problem continues, contact the vendor.
See Section 1.1.1 on page 26

9.3 NSA-2400 Login and Access

I forgot the IP address for the NSA-2400.
• The default IP address is 192.168.1.3.
• Use the NDU (NSA Discovery Utility) to discover your NSA-2400. If you have admin
privileges, you can directly change the IP address of the NSA-2400 using the NDU.
• If you changed the default password and you don't have the NDU, use the reset button to
return the device to its factory default settings.
How To
9.3.1 Reset the NSA
If you forget your password or cannot access the web configurator, use the RESET button at
the front of the NSA (check that the RESET button is enabled in the Maintenance >
Configuration screen).
NSA-2400 User's Guide
108. After replacing the disk, turn on the NSA-2400, go to the
for a description of NSA-2400 LEDs.
Chapter 9 Troubleshooting
127