Firmware Upgrade; Firmware Upgrade Screen; Figure 55 Maintenance > Fw Upgrade - ZyXEL Communications NSA-2400 User Manual

Table 51 Maintenance > Configuration
LABEL
Enable/Disable
Hardware Reset
Button
Load Default Button

8.6 Firmware Upgrade

Use this screen to upgrade the NSA-2400 firmware. You should first have downloaded the
latest firmware files from the ZyXEL website.

8.6.1 Firmware Upgrade Screen

Click the Maintenance link in the Navigation panel and then click the FW Upgrade link or
the FW Upgrade tab to access the Maintenance > FW Upgrade screen.
Figure 55 Maintenance > FW Upgrade
NSA-2400 User's Guide
DESCRIPTION
When the screen button reads Disable Hardware Reset Button, it
means the button on the NSA-2400 is already enabled. if you forget yur
(admin) password, you can use the reset button the device to reset it to
'1234' again.
Click Disable Hardware Reset Button to stop anyone from resetting the
physical hardware reset button on the NSA-2400.
Note: If you disable the reset button, you will not be able to
access the device if you forget your password. Make
sure you write it down and keep it in a safe place.
When the button on the screen reads Enable Hardware Reset Button, it
means the reset button on the NSA-2400 is disabled.
When you change the reset button setting, a pop-up screen appears
asking you to confirm. Click OK to continue or Cancel to quit.
Click this button to reload the factory default settings:
• IP address: 192.168.1.3
• username: admin
• password: 1234
Chapter 8 Maintenance Screens
121