Lock Washers/Plates And Cotter Pins; Bearings And Oil Seals; Circlips - Yamaha Sirius T110LSE Service Manual

OR
1
1
1
3
4
IMPORTANT INFORMATION
300-000
300-003
300-002
1
2
300-001
1-3
EAS00023
LOCK WASHERS/PLATES AND COT-
TER PINS
After removal, replace all lock washers/plates 1
and cotter pins. After the bolt or nut has been
tightened to specification, bend the lock tabs
along a flat of the bolt or nut.
EAS00024

BEARINGS AND OIL SEALS

Install bearings and oil seals so that the manu-
facturer's marks or numbers are visible. When
installing oil seals, lubricate the oil seal lips with
a light coat of lithium-soap-based grease. Oil
bearings liberally when installing, if appropriate.
1 Oil seal
cC
Do not spin the bearing with compressed air
because this will damage the bearing sur-
faces.
1 Bearing
EAS00025

CIRCLIPS

Before reassembly, check all circlips carefully
and replace damaged or distorted circlips.
Always replace piston pin clips after one use.
When installing a circlip 1, make sure the
sharp-edged corner 2 is positioned opposite
the thrust 3 that the circlip receives.
4 Shaft
GEN
INFO