Important Information; All Replacement Parts; Gaskets, Oil Seals, And O-Rings; Lock Washers/Plates And Cotter Pins - Yamaha XC125 Service Manual

MPO.TAOT NFO.MAT ON
IMPORTANT INFORMATION
ALL REPLACEMENT PARTS
1. We recommend to use Yamaha genuine
parts for all replacements. Use oil and/or
grease recommended by Yamaha for assem-
bly and adjustment.
|J
GASKETS, OIL SEALS, AND O-RINGS
1. All gaskets, seals, and O-rings should be
replaced when an engine is overhauled. All
gasket surfaces, oil seal lips, and O-rings
must be cleaned.
2. Properly oil all mating parts and bearings
during reassembly. Apply grease to the oil
seal lips.
LOCK WASHERS/PLATES AND COTTER PINS
1. All lock washers/plates (_ and cotter pins
must be replaced when they are removed.
.__ Lock tab(s) should be bent along the bolt
//////////_ or nut flat(s) after the bolt or nut has been
properly tightened.
BEARINGS AND OIL SEALS
1. Install the bearing(s) (_ and oil seal(s) (_)
with their manufacturer's marks or numbers
facing ou_tward. (In other words, the
stamped letters must be on the side exposed
to view.) When installing oil seal(s), apply a
light coating of light-weight lithium base
grease to the seal lip(s). Oil the bearings
liberally when installing.
___ Do not use compressed air to spin the bearings
dry. This causes damage to the bearing surfaces.
1-2