Regency L390E Owner's Manual page 18

INSTALLATION
6) Ensure the rubber gasket, which is prefi tted as part of the Assembly,
is properly positioned. Install the new Pressure Regulator using the 2x
M4 x .7 screws supplied. Tighten the screws to 25lb-in. In the event that
the screw threads are cross threaded or stripped, replace the valve
assembly.
Install the enclosed propane identifi cation label to the valve body where it
can be easily seen.
7) Re-attach the Pressure Regulator wire, and re-situate the Gas Valve,
secure the screws that fasten the Gas Valve Mounting Brackets.
8) Remove burner (see burner removal section in manual).
Important: FOR NG UNITS ONLY:
9) If top bracket is installed.
a) Loosen 3 screws on the bottom bracket (see below for location).
b) Slide the top bracket off the screws, retighten the screws.
c) Discard top bracket.
Top Bracket
Screw Locations
10) Using a 3/8" socket wrench, loosen and remove the main gas orifi ce.
Replace with the LP gas orifi ce. Confi rm the orifi ce size marked on the
Orifi ce with the Rating Label on the appliance
18
11) Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifi ce.
Pilot retainer clip
12) Unscrew the pilot orifi ce with the allen key; then replace with the LPG
pilot orifi ce and the pilot cap, provided in the kit.
13) Ensure the pilot light is in the correct orientation to the Burner.
Reconnect the gas and electrical supply to the appliance. Start the
appliance. (see section on Lighting Instructions) Ensure that pilot and
burner ignition is completed without delay. Check both your inlet and
outlet pressures at full load. With a soapy solution, leak test the entire
system. Verify both the correct fl ame and pilot appearance.
14) See Gas Pipe Pressure Testing in manual.
15) Adjust aerations settings - see Air Shutter Adjustment section in the
manual.
Installer Notice:
These instructions must be left
with the appliance
.
L390E-2 / HZI390E-2 Direct Vent Gas Insert