Threading The Machine; Drawing Up Bobbin Thread - Kenmore 385.15208 Owner's Manual

Threading the Machine
° Threading the machine
* Raise the thread take*up lever to its highest position by
turning the handwheei counterclockwise,
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off as
shown,.
[] Draw the end of thread around the upper thread guide.
[] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[] Firmly draw the thread up and from right to left over the
take-up lever then down into the take-up lever eye.
[]Slide the thread behind the needle bar thread guide on
the left,.
[_Thread the needle from front to back.
° Drawing up bobbin thread
[] Raise the presser foot.. Hold the needle thread lightly
with your left hand_
[] Rotate the handwheel counterclockwise, toward you, for
one complete turn. Bring the bobbin thread up by puEling
the needle thread up_
[_ Pull both threads 4" to 6" (I00 to 15..0 cm) under and
behind the presser foot,.
f
.I-fl
[]
[]
f
oj
%
, .,,,'
J
........ J
24