Panasonic KX-HCM230 Operating Instructions Manual page 75

Data transfer method:
Please use [Passive Mode] normally. If FTP does not work properly,
please ask ISP or network administrator about the transferring mode of
FTP server. [Passive Mode] or [Active Mode] is available.
b.
Mail: Sets the SMTP and POP3 server address*
Login ID*
From (Reply)*
same address as From (Reply).
To * : Enter the e-mail address of receiver.
3
Subject & Text *
Time in 24 h mode is attached on the subject.
Notes
• Please set POP3 server address or Host Name, Login ID and
Password if you need POP authentication to send the e-mail.
Please ask ISP or administrator.
• The Network Camera will only operate correctly with SMTP (Simple
Mail Transfer Protocol) server. It is not available with the Internet
accessed mail server like "Hotmail" or others accessed via the web
browser.
* Please refer to IP addressing on Page 101.
1
* Please refer to unavailable character set 1 on Page 101.
2
* Please refer to unavailable character set 2 on Page 101.
3
* Only ["] is unavailable in the ASCII character table on Page 101
4
and please refer to displayable character set on Page 102.
2.
Select/Enter the each parameter. Click [Save] when finishing.
• Click [Cancel] to quit the current settings. It returns to the Setup Page
without saving the parameters.
• Click [Clear Buffered images] to clear the buffered image.
[Clear Buffered images] does not save the parameters.
Note
Please refer to Page 44 for the Buffered Image.
and Password* .
2 2
: Enter the e-mail address of [Reply-to]. [To] can be the
3
: Sets the subject and text of the e-mail.
4
Operating Instructions
or Host Name* ,
1 2
75