How To Turn On Network Camera For Installation - Panasonic KX-HCM230 Operating Instructions Manual

Operating Instructions
2.3 How to turn on Network Camera for
Installation
Connect the DC plug of the AC adaptor to the DC IN jack (1.) and Category 5
straight/cross cable to the Ethernet port (2.). Attach the AC cord to the AC adaptor
(3.). Connect the AC plug to the power outlet (4.).
DC IN
jack
Ethernet
port
Notes
• AC adaptor is used as the main disconnect device, ensure that the power
outlet is located/installed near the equipment and is easily accessible.
• Use Only with specified Panasonic AC adaptor PSLP1238 (Order No.
PSLP1238Z).
• AC Adaptor is for indoor use only.
• After you have finished setting up the Network Camera, please go to
Section 4.1 Network Camera Installation for Outdoor Cabling and
Mounting.
• When you set up the Network Camera in [Type 3], please connect the
Network Camera temporarily in [Type 1], [Type 2] or [Type 4].
20
AC adaptor
(1.)
DC Plug
Category 5 straight/cross cable
(2.)
(4.)
AC cord
Power
Outlet
(3.)
To Network