HP OmniBook 3100 Service Manual page 77

Serial Port
Base I/O address
Infrared Port
Mode
Base I/O address
DMA channel
Parallel Port
Mode
Base I/O address
Interrupt
DMA channel
Audio
SB I/O address
WSS I/O address
AdLib I/O address
Interrupt
1st DMA channel
2nd DMA channel
OmniBook 3000:
MPU Device
OmniBook 3000:
MPU I/O address
OmniBook 3000:
Interrupt
Security Menu
OmniBook 2100/3100:
User Password Is
OmniBook 2100/3100:
Administrator Password Is
OmniBook 2100/3100:
Set User Password
OmniBook 2100/3100:
Set Administrator
Password
OmniBook 3000 only:
System Password is
OmniBook 3000 only:
Set System Password
Boot
HP OmniBook 2100/3000/3100
Sets how the serial port is configured by the BIOS (specified
or automatic).
Sets the I/O address and interrupt.
Sets how the infrared port is configured by the BIOS (specified
or automatic).
Sets the hardware to support SIR (Standard IR), ASK IR
(amplitude shift keyed IR), or FIR (Fast IR) infrared
communications. (Driver installation required.)
Sets the I/O address and interrupt.
For Fast IR mode, sets the DMA channel.
Sets how the parallel port is configured by the BIOS (specified
or automatic).
Sets the port to normal, bi-directional, EPP, or ECP.
Sets the I/O address.
Sets the interrupt.
For ECP mode, sets the DMA channel.
Sets how the audio system is configured by the BIOS
(specified or automatic).
Sets the Sound Blaster I/O address.
Sets the Windows Sound System I/O address.
Sets the AdLib synthesizer I/O address.
Sets the interrupt.
Sets the DMA channel for playback.
Sets the DMA channel for recording.
Sets how the MIDI capability is configured: by the BIOS
(specified settings or automatic) or by a PnP operating
system. The port replicator provides a MIDI port, but the
OmniBook does not.
Sets the MIDI I/O address.
Sets the interrupt.
Shows if a user password is set.
Shows if an administrator password is set.
Press ENTER to set, change, or clear user password.
Password length can be no longer than 8 characters, 0-9, A-Z.
Press ENTER to set, change, or clear administrator password.
This password protects BIOS Setup settings.
Shows whether a password is set.
Press ENTER to set, change, or clear the password.
Password length can be no longer than 8 characters, 0-9, A-Z.
Sets whether a user password is required when the computer
boots.
Troubleshooting and Diagnostics
Enabled
3F8h, IRQ4
(COM1)
Disabled
SIR
2F8h, IRQ3
(COM2)
DMA3
Enabled
ECP
378h
IRQ7
DMA3
Enabled
220h
530h
388h
IRQ5
DMA1
DMA0
Disabled
330h
IRQ9
Default
Clear
Clear
Clear
OB 2100/3100:
Enabled
OB 3000:
Disabled
3-23