Fixed Legrests; Angle Adjustable Legrests - Invacare XLT Dynamic Manual

Tools: 5 mm Allen Key
1.
A
2.
B
C
INVACARE ® XLT

FIXED LEGRESTS

C
A

ANGLE ADJUSTABLE LEGRESTS

Tools: 5 mm Allen Key
Height adjustment
Adjust the height of the footrests by loosening the
screw (A) with an Allen key. When adjusting the height
a clicking sound will occur. One "click" is one step in
height. Pull the legrest until you have obtained the
correct height and the screw is caught by one of the
recesses on the legrest tube. Then retighten screw.
NOTE! Do not adjust the upper screw (C).
The distance between the lowest part of the
footrest and the floor or ground must be at
least 40 mm.
Angle adjustable legrests support the legs and reduce
pressure. The legrests can be used for bandaged legs,
but not for legs in plaster casts. The legrests must
always be fitted with calf pads, footplates and heel
straps.
It is important to adjust the height and angle of the
legrests to obtain a good seating position.
1. Height adjustment
Loosen screw (A) with an Allen key. Adjust the
legrest into a suitable height and the screw is
caught by one of the recesses on the legrest tube.
Then retighten the screw.
2. Angle adjustment
Pull the lever (B) with one hand while support-
ing the legrest with your other hand. When a
suitable angle is obtained, let go of the lever and
the legrest will look into one of seven preset
positions (C).
Do not place anything heavy, or let children
sit on the legrest. It may cause damage to the
mechanism.
The distance between the lowest part of
the footrest and the ground must be at least
40 mm.
13