BEFORE FIRST USE
• Remove any packaging material and any labels from the appliance.
• As some parts may be packed separately, check to ensure all items have been
unpacked before disposing of the packaging.
• Clean all parts as instructed in the "CARE AND MAINTAINANCE" section of this
manual
POSITIONING & PREPARATION
• Place the roaster on a stable, level, heat-resistant surface, in a well ventilated
area, with the lid closed.
• Do not put it near or below curtains or other combustible materials.
• Position the cable so it doesn't overhang, and cannot be tripped over or caught.
• Always use oven mitts once the appliance is turned on. They not only protect
your hands from the heat, they protect them from drips and splashes too.
• Push the drip tray under the roaster, so it catches any run-off.
CONDITION THE COOKING PLATES
Note: Conditioning the cooking plates will help prolong the life of the non-stick
coating.
• Lift the lid and wipe the upper and lower cooking plates lightly with cooking oil.
• Close the lid.
• Put the plug into the power socket
• The display will show dashes -- (standby).
• Press .
• The display will begin to preheat and PH and 5 (that's 5 minutes) will appear on
the display. It will then start to count down.
• When it reaches 0, it will beep 4 times, and change to on.
• Switch the power off at the wall power out let, remove the plug and allow the
roaster to cool.
• Wipe off any excess oil with a dry paper towel and close the lid.
PREHEAT
• Close the lid.
• Put the plug into the power socket
• The display will show dashes '—' which indicates the appliance is on standby.
• Press to turn on
• The appliance will automatically begin to preheat, which will take 5 minutes. The
display will flash between PH and 5 (meaning 5 minutes) and will start to count
down the minutes of preheating that remain.
• When the display reaches 0, it will beep 4 times, and then the display will change
to "on" and will continue to flash. The unit will remain on and heating.
5