Maintenance Page Definitions - Grandstream Networks GXP1450 User Manual

802.1X Client Certificate
HTTP Proxy
HTTPS Proxy
Layer 3 QoS
Layer 2 QoS
802.1Q/VLAN Tag
Layer 2 QoS 802.1p
Priority Value
PC Port Mode
Enable LLDP

MAINTENANCE PAGE DEFINITIONS

Maintenance -> Web Access
Disable Telnet
End User Password
Confirm Password
Admin Password
Confirm Password
Maintenance -> Upgrade and Provisioning
Firmware Upgrade and
Provisioning
XML Config File
Password
HTTP/HTTPS User
Name
FIRMWARE VERSION 1.0.5.58
Upload 802.1X Client certificate to the phone; or delete existed 802.1X Client
certificate from the phone.
Specifies the HTTP proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Specifies the HTTPS proxy URL for the phone to send packets to. The proxy
server will act as an intermediary to route the packets to the destination.
Defines the Layer 3 QoS parameter. This value is used for IP Precedence,
Diff-Serv or MPLS. The default value is 12.
Assigns the VLAN Tag of the Layer 2 QoS packets. The default value is 0.
Assigns the priority value of the Layer2 QoS packets. The default value is 0.
Configures the PC port mode. When set to "Mirrored", the traffic in the LAN
port will go through PC port as well and packets can be captured by
connecting a PC to the PC port. The default setting is "Enable".
Control the LLDP(Link Layer Discovery Protocol) service.
Disables Telnet access. The default setting is "No".
Allows the administrator to set the password for user-level web GUI access.
This field is case sensitive with a maximum length of 30 characters.
Confirms the end user password field to be the same as above.
Allows users to change the admin password. The password field is purposely
hidden for security purpose. This field is case sensitive with a maximum length
of 30 characters.
Confirms the admin password field to be the same as above.
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
changes, Always Skip the Firmware Check.
The password for encrypting the XML configuration file using OpenSSL. This
is required for the phone to decrypt the encrypted XML configuration file.
The user name for the HTTP/HTTPS server.
GXP2120/GXP2110/GXP2100/GXP14xx USER MANUAL Page 65 of 80