Oki Microline Ml184T+ Handbook page 18

2. Snap the two wire locking tabs on to the plug.
3. Insert the other end of the cable into your computer. You may also
connect it to another peripheral device, such as a disk drive, if your
equipment is designed for daisychain connection.
4. Turn on the equipment and try the one line BASIC program shown
below, using the proper print statement for your computer (the exam-
ple uses LPRINT). Make sure you have paper and ribbon in the printer.
5. Type: LPRINT "Everything's okay" and then run the program.
6. Your printer should print "Everything's okay" at 10 characters per inch.
Note: If the printer did not print, make sure you entered the program correctly. Some com-
puters require that you assign a number to the printer and specify that number in your print
statement; for example OPEN # 3 means the printer is on line # 3 to the computer.
7. Now try this BASIC program (change it, if necessary, to suit your
computer's requirements):
10 LPRINT "EVERYTHING'S OKAY"
20 LPRINT "THIS LINE SHOULD BE SPACED 1/6"";
CHR$(34);"UNDER THE FIRST"
8. The printout should look like this:
EVERYTHING'S OKAY
THIS LINE SHOULD BE SPACED 1/6" UNDER THE FIRST
1 -- 12 Setting Up