Oki Microline Ml184T+ Handbook page 53

2. Release the paper guides by pushing the fixing levers downwards.
3. Move the left paper guide to the position where you wish to set the
left-hand edge of the sheet. Make sure that this guide is not set to the
right of the paper out sensor (the groove in the platen).
Left paper guide
4. Flex the paper stack (not more than 170 sheets of 60g/m
per). Square the stack again, turn it over, and repeat the bending. The
paper stack should not exceed 16mm in total thickness.
1 2
Right paper guide
2
(161b) pa-
Operating Your Printer 2 -- 31