Air Filters; Condenser; Preparing The Icemaker For Long Storage - Hoshizaki KMD-410MAH Instruction Manual

3. Air Filters (air-cooled model only)
Plastic mesh air filters remove dirt and dust from the air, and keep the condenser from
getting clogged. As the filters get clogged, the icemaker's performance will be reduced.
Check the filters at least twice a month. When clogged, use warm water and a neutral
cleaner to wash the filters.
4. Condenser (air-cooled model only)
Check the condenser once a year, and clean if required by using a brush or vacuum
cleaner. More frequent cleaning may be required depending on the location.
C. Preparing the Icemaker for Long Storage
1. When shutting off the icemaker for an extended time, drain out all water
from the water line and remove the ice from the storage bin/dispenser
unit. The storage bin/dispenser unit should be cleaned and dried. Drain
the icemaker to prevent damage to the water supply line at sub-freezing
temperatures, using air or carbon dioxide. Shut off the icemaker until the
proper ambient temperature is resumed.
2. To prevent damage to the water pump, do not leave the control switch in
the "SERVICE" position for extended periods of time when the water tank
is empty.
When the icemaker is not used for two or three days, it is sufficient to only move the control
switch to the "OFF" position, unless the icemaker will be at sub-freezing temperatures.
1. On water-cooled model only, first remove the water from the water-cooled

condenser:

1) Turn off the power supply and remove the front panel.
2) Move the control switch on the control box to the "OFF" position.
3) Wait 3 minutes.
4) Move the control switch to the "ICE" position.
5) Replace the front panel in its correct position and turn on the power supply.
CAUTION
20